Disassembly note
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Disassembly and Assembly (Coil spring) › Disassembly note
SuspensionDisassembly note
Disassembly note
Coil spring
- Loosen the piston rod upper nut several turns, but do not remove the nut.
Caution
- Do not remove the nut.
- Use copper or aluminum plates in the jaws of the vise.
- Assemble the SST.
- Compress the coil spring with the SST, and remove the upper nut.
- Remove the coil spring.
Assembly note
Coil spring and bound stopper
- Set the shock absorber in a vise.
- Install the bound stopper on the shock absorber as shown.
- Install the compressed coil spring (compressed with SST).
- Install the mounting plate.
- Remove the SST.
- Secure the mounting plate in a vise.
Caution
- Use copper or aluminum plates in the jaws of the vise.
- Tighten the piston rod upper nut.
Tightening torque:
31—46 Nm (3.2—4.7 m-kg, 23—34 ft-lb)
Parts & tools for this job For 1990 Mazda MX-5
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTShock absorbersSearch: Mazda MX-5 1990 shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.