Toe-in
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- R Suspension (R) › Toe-in
SuspensionToe-in
Note
- If the cam cannot be turned far enough to make the adjustment, begin again at adjustment of the caster using the other cam.
- Tighten the nuts.
Tightening torque:
73—95 N·m (7.4—9.7 m·kg, 54—70 ft-lb)
- Adjust the toe-in.
Toe-in
- Remove the steering gear boot clamp.
- Loosen the left and right tie-rod locknuts, and turn the tie-rods by the same amount.
Caution
- The left and right tie-rods are both right threaded. To increase the toe-in, turn the right tie-rod toward the front of the vehicle, and turn the left tie-rod by the same amount toward the rear.
- One turn of the tie-rod (one side) changes the toe-in by about 7mm (0.28 in).
- Adjust the toe-in after adjusting the steering angle.
- Tighten the tie-rod locknuts to the specified torque.
Tightening torque:
34—39 N·m (3.5—4.0 m·kg, 25—29 ft-lb)
- Verify that the boot is not twisted, and install the boot clamp.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTShock absorbersSearch: Mazda MX-5 1990 shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.