Specifications (Unladed*)
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Specifications (Unladed*) › Specifications (Unladed*)
SuspensionSpecifications (Unladed*)
Specifications (Unladed*)
| Item | Specifications | ||
|---|---|---|---|
| Total toe-in | mm (in) | 3 ± 3 (0.12 ± 0.12) | |
| degree | 0°18' ± 18' | ||
| Camber angle | Height from center of wheel to fender brim mm (in) | 346—355 (13.6—14.0) | −1°08' ± 30' |
| 356—365 (14.0—14.4) | −0°54' ± 30' | ||
| 366—375 (14.4—14.8) | −0°43' ± 30' | ||
| 376—385 (14.8—15.2) | −0°35' ± 30' | ||
| 386—395 (15.2—15.6) | −0°30' ± 30' | ||
* Fuel tank full, radiator coolant and engine oil at specified levels; spare tire, jack, and tools in designated positions.
Toe-in
Toe-in is adjusted by turning the front and/or rear adjusting cam bolt at the lower arm.
Caution
- Adjust the toe-in before adjusting the camber.
- Loosen the front and/or rear cam nut.
- Turn the front and/or rear adjusting cam bolt to provide the correct toe-in.
| Toe-in | Left wheel | Right wheel | ||
|---|---|---|---|---|
| Front cam | Rear cam | Front cam | Rear cam | |
| Increase | Counter-clockwise | Counter-clockwise | Clockwise | Clockwise |
| Decrease | Clockwise | Clockwise | Counter-clockwise | Counter-clockwise |
Note
- Turning the front cam one graduation changes the toe-in about 2.8mm (0.11 in) and the camber about 15'. Turning the rear cam one graduation changes the toe-in about 2.8mm (0.11 in) and the camber about 6'.
- Adjust the camber.
Camber
Camber is adjusted by turning the front and rear cams at the lower arm.
Caution
- Adjust the camber after adjusting the toe-in.
- Loosen the front and rear cam nuts.
- Turn the front and rear adjusting cam bolts the same amount in the opposite direction to provide the correct camber angle.
Parts & tools for this job For 1990 Mazda MX-5
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.