Removal / Installation
- Make
- Mazda
- Model
- MX-5 (NA) Factory Workshop Manual
- Year
- 1990–1992
- Section
- Troubleshooting › Removal / Installation
Body electrical systemRemoval / Installation
Symptom: Stoplights does not operate (one only).
Step 1
Check the stoplight bulb of the faulty side.
If a bulb is burned replace it.
If the bulb is OK, go to Step 2.
Step 2
Measure the voltage at the following terminal-wires of the faulty stoplight connector.
| Inspection condition | Wire | Voltage | Action |
|---|---|---|---|
| Brake pedal depressed |
(G) | 12V | Next check wire (B) |
| 0V | Repair wire (G) (Stoplight switch—Stoplight) |
||
| (B) | 12V | Repair ground wire (B) | |
| 0V | Check for poor connection of connectors |
Removal / Installation
Remove and install as shown in the figure.
Parts & tools for this job For 1990 Mazda MX-5
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.