Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)13 · Body and cab accessories
13 · Body & interior

Condition

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Security and Locks › Condition
Body and cab accessoriesCondition

CAUTION: Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed:

Card key

M-MDS

Personal computer

Devices that can send/receive the radio waves

Condition

  • Have two or more valid keys.

NOTE: A maximum of eight keys can be programmed for one vehicle. If key programming is not successful and DTC 15 appears even though the procedure was performed properly, use the PID/data monitor function of the M-MDS and verify the number of keys that have been programmed.

If eight keys have already been programmed, and it is necessary to program other keys, the previously programmed key ID numbers must first be cleared. To clear the key, refer to "NO.3 PCM REPLACEMENT PROCEDURE".

Procedure

ACCESSORIES & BODY, CAB – Security and Locks (Advanced Keyless System) – figure
Fig. 23: Identifying Valid Key And Key For Registration
Courtesy of MAZDA MOTORS CORP.
  1. Prepare key 3 for programming.
  2. Start the engine using key 1.
  3. Verify that the security light illuminates for approx. 3 s , and then goes out.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.