Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)13 · Body and cab accessories
13 · Body & interior

Procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Security and Locks › Procedure
Body and cab accessoriesProcedure

Key Programming Procedure (Using Two Valid Keys)" setting.

  • This procedure is possible when the vehicle is new, and when replacing the keyless unit with a new one.
  • If "No.1 Additional Key Programming Procedure (Using Two Valid Keys)" is set to disable, the additional key programming can be only performed using the M-MDS preventing the forging of a spare key by using two keys that can start the engine. This function is for use by rental car agencies or other companies with vehicle fleets.

Procedure

  1. Using the key, turn the ignition switch to the ON position. (The key can be either the valid key or an unprogrammed key)

NOTE: Although the security light flashes and DTC 15 is displayed when an unprogrammed key is used, this does not indicate an improper procedure. Continue to perform the procedure as indicated.

  1. Connect the M-MDS to the DLC-2.
  2. Select "BODY/SECURITY/PATS functions" from the M-MDS screen menu.
  3. Select "Customer spare key programming enable" or "Customer spare key programming disable" from the M-MDS screen menu. The key additional programming procedure is as follows according to the selected menu:

ADDITIONAL KEY PROGRAMMING PROCEDURE

Additional key programming procedure

Setting

Method using two valid keys Method using the M-MDS

Customer spare key programming enable

-

-

Customer spare key programming disable

x

-

-: Available x: Unavailable

  1. Perform the security access according to the directions on the M-MDS screen. (See SECURITY ACCESS PROCEDURE[ADVANCED KEYLESS SYSTEM] .)
  2. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Exit (From This Menu)" to finish the M-MDS procedure.
  3. After Step 6, wait 5 s or more and then turn the ignition switch to the LOCK position.

NO.5 RESETTING PROCEDURE FOR THE IMMOBILIZER SYSTEM WHEN REPLACING THE

RELATED PARTS (PCM, KEYLESS CONTROL MODULE, INSTRUMENT CLUSTER, OR

STEERING LOCK UNIT)

Condition

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.