Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Abs hu/cm inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Antilock Brake System (2008) › Abs hu/cm inspection
BrakesAbs hu/cm inspection
BRAKES – Antilock Brake System (2008) – figure
Fig. 9: Locating DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.
  1. After the Vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
  2. Select the "Module Programming".
  • When using the PDS (Pocket PC)
  1. Select "Programming".
  2. Select "Module Programming".
  3. Then, select the "Programmable Module Installation" and "ABS" from the screen menu.
  4. Perform the configuration according to the directions on the screen.
  5. Retrieve DTCs using the M-MDS, then verify if DTCs are present.
    • If a DTC is present, perform the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC (ABS) -- MX-5 MIATA )

ABS HU/CM INSPECTION

  1. Disconnect the ABS HU/CM connector.
  2. Connect the negative battery cable.
  3. Attach the tester lead to the ABS HU/CM harness side connector, then inspect voltage, continuity or resistance according to the standard (reference value) on STANDARD (REFERENCE VALUE)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.