Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Operation Inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Antilock Brake System (2008) › Operation Inspection
BrakesOperation Inspection

3s .

  1. Turn the ignition switch off.
  2. Jack up the vehicle and support it evenly on safety stands.
  3. Shift to neutral.
  4. Release the parking brake.
  5. Verify that all four wheels rotate.
  6. Rotate the wheels by hand, and verify there is no brake drag.
    • If there is any brake drag, perform regular brake inspection.
    • If there is no brake drag, perform ABS HU/CM operation inspection.

Operation Inspection

  1. Perform "Preparation".
  2. Connect the M-MDS or equivalent to the DLC-2.
  3. Set up an active command mode inspection according to the combination of commands below.
BRAKES – Antilock Brake System (2008) – figure
Fig. 3: Locating DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.

ACTIVE COMMAND MODE INSPECTION REFERENCE TABLE

Command name

Operation

Command

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.