Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Engine coolant replacement [lf] (page 2 of 2)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Cooling System
EngineEngine coolant replacement [lf] · page 2 of 2

cause serious injury. It may also damage the engine and cooling system.

  • Turn off the engine and wait until it is cool. Even then, be very careful when removing the cap. Wrap a thick cloth around it and slowly turn it counterclockwise to the first stop. Step back while the pressure escapes.
  • When you are sure all the pressure is gone, press down on the cap using the cloth, turn it, and remove it.

CAUTION: Use engine coolant at a concentration that meets the environmental conditions in which the vehicle is driven, otherwise engine damage could occur.

The engine has aluminum parts and must be protected by an ethylene-glycol-based coolant to prevent corrosion and freezing.

Do not use coolants containing Alcohol, Methanol, Borate or Silicate. These coolants could damage the cooling system.

Use only soft (demineralized) water in the coolant mixture. Water that contains minerals will cut down on the coolant's effectiveness.

Engine coolant damages paint. If engine coolant does get on a painted surface, rinse it off quickly.

NOTE: If the "FL22" mark is shown on or near the cooling system cap, use FL22 type engine coolant.

FL22 type engine coolant is shipped as a diluted solution (55% coolant, 45% water). Use the solution as is when replacing coolant.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.