Airflow inspection
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Intake Air System › Airflow inspection
‹ Prev Variable intake air solenoid valve removal/installation [lf]Next › Circuit open/short inspection
Engine performanceAirflow inspection
NOTE: Perform the following inspection only when directed.
AIRFLOW INSPECTION
- Remove the battery cover
- Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
- Remove the variable intake air solenoid valve. (See VARIABLE INTAKE AIR SOLENOID VALVE REMOVAL/INSTALLATION [LF] .)
- Inspect airflow between the ports under the following conditions.
- If not as specified, replace the variable intake air solenoid valve.
- If as specified, carry out the Circuit Open/Short Inspection .
Courtesy of MAZDA MOTORS CORP.
‹ Prev Variable intake air solenoid valve removal/installation [lf]Next › Circuit open/short inspection
Parts & tools for this job For 2006 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 2006 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.