MX-5 (NC) Factory Workshop Manual (2006-2008): Engine performance
Also for this vehicle: MX-5 (NA) Factory Workshop Manual (1990-1992).
General
Engine
Transmission
Steering & suspension
Brakes
Body & interior
Heating & A/C
Electrical
Choose Sections to see everything in a chapter, or a chapter title to start at its first page.
General
Engine
Emission System51 pages
- 2006-2008 ENGINE PERFORMANCE – Emission System - MX-5 Miata
- Fuel tank side23
- Emission system diagram [lf]2
- Air filter inspection [lf]
- Charcoal canister removal/installation [lf]
- Evaporative hose installation note
- Charcoal canister inspection [lf]
- Evaporative emission (evap) system leak detection pump removal/installation [lf]2
- Evaporative hose installation note
- Evaporative emission (evap) system leak detection pump inspection [lf]
- Resistance inspection
- Circuit open/short inspection
- Short Circuit
- Purge solenoid valve removal/installation [lf]
- Purge solenoid valve inspection [lf]
- Circuit open/short inspection
- Open Circuit23456
- Egr valve inspection [lf]2
- Circuit open/short inspection
- Positive crankcase ventilation (pcv) valve inspection [lf]
- Warm-up three-way catalytic converter (wu-twc) inspection [lf]234
- Rollover valve removal/installation [lf]
- Fuel shut-off valve inspection [lf]
- Evaporative chamber inspection [lf]
- Type a removal2
- Type b removal
- Type c removal2
- Type d removal
- Type a installation
- Type b installation2
- Type c installation2
- Type d installation23
Engine Control System101 pages
- 2006-2008 ENGINE PERFORMANCE – Engine Control System - MX-5 Miata2
- Control system diagram [lf]23
- Pcm removal/installation [lf]
- Pcm connector connected note
- Pcm terminals voltage specification table234567891011
- Inspection using an oscilloscope (reference)
- Oscilloscope Setting
- OCV Control Signal
- Vehicle Speed Signal
- CMP Signal
- CKP Signal
- Generator Field Coil Control Signal
- Generator Output Voltage Signal
- Ignition Timing Signals
- Fuel Injection Signals
- Front HO2S Heater Control Signal
- Using the m-mds or equivalent2
- PID/DATA Monitor Table (Reference)2345678910111213
- Pcm configuration [lf]
- Neutral switch inspection [lf]
- Open Circuit
- Short Circuit
- Open Circuit
- Power steering pressure (psp) switch inspection [lf]
- Open Circuit
- Engine coolant temperature (ect) sensor removal/installation [lf]23
- Engine coolant temperature (ect) sensor inspection [lf]
- Resistance inspection2
- Open Circuit
- Mass air flow (maf) sensor inspection [lf]
- Voltage inspection
- Intake maf (g/s) and engine load calculated value specification
- Resistance inspection
- Circuit open/short inspection
- Open Circuit
- Manifold absolute pressure (map) sensor inspection [lf]
- Circuit open/short inspection2
- Open Circuit2
- Circuit open/short inspection2
- Open Circuit
- Circuit open/short inspection2
- Open Circuit
- Visual inspection
- Ckp sensor voltage specification
- Circuit open/short inspection
- Open Circuit
- Installation2
- Camshaft position (cmp) sensor removal/installation [lf]
- Camshaft position (cmp) sensor inspection [lf]
- Visual inspection
- Cmp sensor terminals voltage specification2
- Open Circuit
- Front heated oxygen sensor (ho2s) inspection [lf]
- Front ho2s heater resistance inspection
- Front ho2s circuit open/short inspection2
- Open Circuit
- Rear heated oxygen sensor (ho2s) removal/installation [lf]
- Rear ho2s voltage inspection
- Rear ho2s circuit open/short inspection2
- Open Circuit
- Knock sensor (ks) removal/installation [lf]
- Circuit open/short inspection
- Open Circuit2
Intake Air System25 pages
- 2006-2008 ENGINE PERFORMANCE – Intake Air System - MX-5 Miata
- Intake air system diagram [lf]
- Intake manifold vacuum inspection [lf]2
- Air cleaner cover removal note234567
- Throttle body installation note
- Air cleaner element inspection [lf]
- Specification
- Open Circuit
- Variable intake air solenoid valve removal/installation [lf]
- Airflow inspection
- Circuit open/short inspection
- Open Circuit
- Variable intake air shutter valve actuator inspection [lf]
- Variable intake air shutter valve actuator rod operation reference2
- Variable intake air shutter valve actuator removal note
- Variable intake air shutter valve actuator installation note2
Symptom Troubleshooting152 pages
- 2006-2008 ENGINE PERFORMANCE – Symptom Troubleshooting - MX-5 Miata23
- Foreword [lf]23
- Quick diagnostic table [lf]234
- No.1 melting of main or other fuses [lf]
- [troubleshooting hints]2
- No.2 mil illuminates [lf]
- No.3 will not crank [lf]2345
- No.4 hard to start/long crank/erratic start/erratic crank [lf]2
- Diagnostic procedure23
- No.5 engine stalls-after start/at idle [lf]2
- Diagnostic procedure2345678
- No.6 cranks normally but will not start [lf]2
- Diagnostic procedure
- Cranks normally but will not start diagnostic procedure table2345678
- No.7 slow return to idle [lf]
- No.8 engine runs rough/rolling idle [lf]2
- Diagnostic procedure2345
- No.9 fast idle/runs on [lf]
- Diagnostic procedure2
- No.10 low idle/stalls during deceleration [lf]
- Diagnostic procedure2
- No.11 engine stalls/quits, engine runs rough, misses,
- Buck/jerk, hesitation/stumble, surges [lf]2
- Diagnostic procedure2345
- No.12 lack/loss of power-acceleration/cruise [lf]2
- Diagnostic procedure2345
- No.13 knocking/pinging-acceleration/cruise [lf]
- Diagnostic procedure
- No.14 poor fuel economy [lf]2
- Diagnostic procedure2
- No.15 emission compliance [lf]2
- Diagnostic procedure2
- No.16 high oil consumption/leakage [lf]
- Diagnostic procedure
- Diagnostic procedure23
- No.18 cooling system concerns-runs cold [lf]
- No.19 exhaust smoke [lf]2
- Diagnostic procedure2
- No.20 fuel odor (in engine compartment) [lf]
- Diagnostic procedure
- No.21 engine noise [lf]
- Diagnostic procedure2
- No.22 vibration concerns (engine) [lf]
- No.23 A/C does not work sufficiently [lf]2
- No.24 A/C is always on or A/C compressor runs continuously [lf]2
- No.25 A/C does not cut off under wide open throttle conditions [lf]
- No.26 exhaust sulphur smell [lf]
- Diagnostic procedure2
- No.27 fuel refill concerns [lf]
- Diagnostic procedure
- No.28 fuel filling shut off concerns [lf]
- Diagnostic procedure
- No.29 spark plug condition [lf]
- Diagnostic procedure2345
- Intermittent concern troubleshooting [lf]
- Inspection Method for Sensor Connectors or Wiring Harnesses
- Inspection Method for Sensors
- Water sprinkling method
- Engine control system operation inspection [lf]
- Finding Irregular Signals
- Input Signal System Inspection For Variable Resistance Type 1
- Standard Power Supply System Inspection For Variable Resistance Type 1
- GND System Inspection For Variable Resistance Type 2
- Electrical Supply System Inspection For Variable Resistance Type 2
- Input Signal System Inspection For Thermistor Type
- GND System Inspection For Thermistor Type
- Electronic throttle control system inspection
- Throttle Position (TP) Sweep Inspection
- Fuel injector operation inspection
- If simulation function of M-MDS or equivalent is not used:
- Fuel cut control system inspection
- If simulation function of M-MDS is not used:
- Fuel pump control system inspection2
- Egr control system inspection
- If simulation function of M-MDS is not used:
- If simulation function of M-MDS is used:
- A/c cut-off control system inspection
- If simulation function of M-MDS is not used:
- If simulation function of M-MDS is used:
- Evaporative emission (evap) system leak inspection2
- EVAP System Malfunction Judgment
- Evaporative System Test Procedure
- EVAP System Leak Inspection Using Leak Tester234
Transmission
Steering and suspension
Brakes
Electrical
Heating and air conditioning
Body