Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Resistance inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Engine Control System › Resistance inspection
Engine performanceResistance inspection

NOTE: Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flow diagram. (See TROUBLESHOOTING PROCEDURE .)

RESISTANCE INSPECTION

  1. Remove the battery cover.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Disconnect the MAF/IAT sensor connector.
  4. Verify that the resistance between MAF/IAT sensor terminals D and E is within the specification.
    • If the monitor item status/specification (reference) is not within the specification, even though the IAT sensor resistance is within the specification, perform the CIRCUIT OPEN/SHORT INSPECTION.
    • If not within the specification, replace the MAF/IAT sensor. (See MASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR REMOVAL/INSTALLATION
ENGINE PERFORMANCE – Engine Control System – figure
Fig. 36: Identifying MAF/IAT Sensor Connectors
Courtesy of MAZDA MOTORS CORP.

STANDARD MAF/IAT SENSOR RESISTANCE SPECIFICATION

Ambient temperature (°C {°F})

Resistance (kilohm)

20 (68}

2.21-2.69

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.