Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Open Circuit

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Engine Control System › Open Circuit
Engine performanceOpen Circuit
ENGINE PERFORMANCE – Engine Control System – figure
Fig. 38: Identifying PCM Harness Side Connectors
Courtesy of MAZDA MOTORS CORP.

Open Circuit

  • If there is no continuity, there is an open circuit. Repair or replace the wiring harness.
  • MAF/IAT sensor terminal D and PCM terminal 1 AT
  • MAF/IAT sensor terminal E and PCM terminal 1 AR

Short Circuit

  • If there is continuity, there is a short circuit. Repair or replace the wiring harness.
  • MAF/IAT sensor terminal E and power supply
  • MAF/IAT sensor terminal D and power supply
  • MAF/IAT sensor terminal D and body ground

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [LF]

  1. Remove the battery cover.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Remove the dynamic chamber. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF] .)
  4. Remove the MAP sensor.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.