Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Visual inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Engine Control System › Visual inspection
Engine performanceVisual inspection
  • If the monitor item condition/specification (reference) is not within the specification, even though there is no malfunction, carry out the CIRCUIT OPEN/SHORT INSPECTION .
ENGINE PERFORMANCE – Engine Control System – figure
Fig. 50: Identifying Air Gap Between Plate Projections At Back Of Crankshaft Pulley & CKP
Sensor
Courtesy of MAZDA MOTORS CORP.

Air gap

0.5-1.5 mm {0.02-0.05 in}

VISUAL INSPECTION

  1. Remove the battery cover.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Remove the CKP sensor. (See CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [LF] .)
  4. Verify that there are no metal shavings on the sensor.
    • If the monitor item condition/specification (reference) is without the specification even though there is no malfunction, carry out the CIRCUIT OPEN/SHORT INSPECTION .

VOLTAGE INSPECTION

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.