Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Short Circuit

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Engine Control System › Short Circuit
Engine performanceShort Circuit
  • Neutral switch terminal 1A and body ground

Short Circuit

  • If there is continuity, there is a short circuit. Repair or replace the wiring harness.
  • Neutral switch terminal 2A and body ground

CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION [LF]

NOTE: Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flow diagram. (See TROUBLESHOOTING PROCEDURE .)

CONTINUITY INSPECTION

  1. Remove the CPP switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION .)
  2. Verify that the continuity between CPP switch terminals D and B is as indicated in Fig. 24 .
ENGINE PERFORMANCE – Engine Control System – figure
Fig. 24: Clutch Pedal Position Switch Continuity Table
Courtesy of MAZDA MOTORS CORP.
  • If the monitor item condition/specification (reference) is not within the specification, even though there is no malfunction, perform the CIRCUIT OPEN/SHORT INSPECTION .

CIRCUIT OPEN/SHORT INSPECTION

  1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [LF] .)
  2. Inspect the following wiring harness for open or short circuit (continuity Inspection).

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.