Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Open Circuit

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Engine Control System › Open Circuit
Engine performanceOpen Circuit

See also: live page (the same text is also in the 2008 2.0L manual)

Fig. 46: Identifying PCM Harness Side Connector
Courtesy of MAZDA MOTORS CORP.

Open Circuit

  • If there is no continuity in the following wiring harnesses, there is an open circuit. Repair or replace the wiring harness.
  • Throttle body terminal C and PCM terminal 2AP
  • Throttle body terminal D and PCM terminal 2AL
  • Throttle body terminal E and PCM terminal 2AO
  • Throttle body terminal F and PCM terminal 2AK

Short Circuit

  • If there is continuity in the following wiring harnesses, there is a short circuit. Repair or replace the wiring harness.
  • Throttle body terminal C and power supply
  • Throttle body terminal D and body ground
  • Throttle body terminal D and power supply
  • Throttle body terminal E and body ground
  • Throttle body terminal F and body ground
  • Throttle body terminal F and power supply

ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION [LF]

NOTE: Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flow diagram. (See TROUBLESHOOTING PROCEDURE .)

  1. Connect the M-MDS or equivalent to the DLC-2.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.