Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Open Circuit

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Engine Control System › Open Circuit
Engine performanceOpen Circuit

See also: live page 1 live page 2 (the same text is also in the 2008 2.0L manual)

Fig. 49: Identifying PCM Harness Side Connector
Courtesy of MAZDA MOTORS CORP.

Open Circuit

  • If there is no continuity in the following wiring harnesses, there is an open circuit. Repair or replace the wiring harness.
  • APP sensor terminal A and PCM terminal 1AJ
  • APP sensor terminal B and PCM terminal 1AV
  • APP sensor terminal C and PCM terminal 1AP
  • APP sensor terminal D and PCM terminal 1AL
  • APP sensor terminal E and PCM terminal 1AS
  • APP sensor terminal F and PCM terminal 1AO

Short Circuit

  • If there is continuity in the following wiring harnesses, there is a short circuit. Repair or replace the wiring harness.
  • APP sensor terminal A and body ground
  • APP sensor terminal B and power supply
  • APP sensor terminal C and body ground
  • APP sensor terminal C and power supply
  • APP sensor terminal D and body ground
  • APP sensor terminal E and power supply
  • APP sensor terminal F and body ground
  • APP sensor terminal F and power supply

CRANKSHAFT POSITION (CKP) SENSOR INSPECTION [LF]

NOTE: Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flow diagram. (See TROUBLESHOOTING PROCEDURE .)

AIR GAP INSPECTION

  1. Verify that the CKP sensor is securely installed.
  2. Using a thickness gauge, measure the air gap between the plate projections at the back of crankshaft pulley and the CKP sensor.
    • If not within the specification, inspect the plate projections for cracks or bending.
    • If there is any malfunction, replace the crankshaft pulley. (See ENGINE REMOVAL/INSTALLATION [LF] .)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.