Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Resistance inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Engine Control System › Resistance inspection
Engine performanceResistance inspection · page 1 of 2

See also: live page 1 live page 2 (the same text is also in the 2008 2.0L manual)

NOTE: Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flow diagram. (See TROUBLESHOOTING PROCEDURE .)

RESISTANCE INSPECTION

  1. Remove the battery cover.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Disconnect the ECT sensor connector.
  4. Remove the ECT sensor. (See ENGINE COOLANT TEMPERATURE (ECT) SENSOR REMOVAL/INSTALLATION [LF] .)
  5. Place the ECT sensor in the water and while increasing the water temperature, measure the resistance between ECT sensor terminals A and B.
    • If the monitor item status/specification (reference) is not within the specification, even though the ECT sensor resistance is within the specification, perform the CIRCUIT OPEN/SHORT INSPECTION.
    • If not within the specification, replace the ECT sensor. (See ENGINE COOLANT TEMPERATURE (ECT) SENSOR REMOVAL/INSTALLATION [LF] .)

STANDARD ECT SENSOR RESISTANCE SPECIFICATION

Water temperature (°C {°F})Resistance (kilohm)
20 {68}35.48-39.20
80 {176}3.65-4.02

CIRCUIT OPEN/SHORT INSPECTION

  1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [LF] .)
  2. Inspect the following wiring harnesses for an open or short circuit. (Continuity inspection)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.