Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Open Circuit

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Engine Control System › Open Circuit
Engine performanceOpen Circuit

See also: live page (the same text is also in the 2008 2.0L manual)

ENGINE PERFORMANCE – Engine Control System – figure
Fig. 60: Identifying PCM Harness Side Connector
Courtesy of MAZDA MOTORS CORP.

Open Circuit

  • If there is no continuity, the circuit is open. Repair or replace the wiring harness.
  • CMP sensor terminal A and PCM terminal 2P
  • CMP sensor terminal B and PCM terminal 2S
  • CMP sensor terminal C and PCM terminal 2AM

Short Circuit

  • If there is continuity, the circuit is shorted. Repair or replace the wiring harness. I
  • CMP sensor terminal A and power supply
  • CMP sensor terminal B and power supply
  • CMP sensor terminal B and body ground
  • CMP sensor terminal C and body ground

FRONT HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION [LF]

  1. Remove the battery cover.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Install the SST to the front HO2S.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.