Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Visual inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Engine Control System › Visual inspection
Engine performanceVisual inspection

See also: live page 1 live page 2 live page 3 live page 4 live page 5 (the same text is also in the 2008 2.0L manual)

VISUAL INSPECTION

  1. Remove the battery cover.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Remove the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [LF] .)
  4. Verify that there are no metal shavings on the sensor.
    • If the monitor item condition/specification (reference) is not within the specification even though there is no malfunction, carry out the CIRCUIT OPEN/SHORT INSPECTION .

VOLTAGE INSPECTION

  1. Install all removed parts.
  2. Idle the engine.

CAUTION: Water penetrating the connector will cause sensor malfunction. To prevent this, be careful not to damage the wiring harnesses or the waterproof connector so as to cause water penetration.

  1. Measure the output voltage using an oscilloscope.
    • If not within the specification, replace the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [LF] .)
    • If the monitor item condition/specification (reference) is not within the specification, even though the voltage is within the specification, carry out the CIRCUIT OPEN/SHORT INSPECTION .

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.