Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Installation

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Engine Control System › Installation
Engine performanceInstallation · page 1 of 2
  1. Remove the air cleaner. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF] .)
  2. Remove the drive belt. (See DRIVE BELT REPLACEMENT [LF] .)
  3. Remove the under cover. (See TRANSVERSE MEMBER REMOVAL/INSTALLATION .)
  4. Disconnect the CKP sensor connector.
  5. Remove the installation bolts to remove the CKP sensor.

INSTALLATION

CAUTION: When foreign material, such as an iron chips, gets on the CKP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect engine control. Be sure there is no foreign material on the CKP sensor when replacing.

  1. Perform the following procedure so that piston No.1 is at the top dead center.
  2. Move the ATF hose slightly out of the way. (AT)
ENGINE PERFORMANCE – Engine Control System – figure
Fig. 54: Identifying ATF Hose
Courtesy of MAZDA MOTORS CORP.
  1. Remove the cylinder block lower blind plug and install the SST.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.