Resistance inspection
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Emission System › Resistance inspection
‹ Prev Evaporative emission (evap) system leak detection pump inspection [lf]Next › Circuit open/short inspection
Engine performanceResistance inspection
EMISSION (EVAP) SYSTEM LEAK DETECTION PUMP REMOVAL/INSTALLATION [LF] ).
- If as specified, perform the following "RESISTANCE INSPECTION".
Courtesy of MAZDA MOTORS CORP.
RESISTANCE INSPECTION
- Inspect resistance of the EVAP system leak detection pump.
- If not as specified, replace the EVAP system leak detection pump. (See EVAPORATIVE EMISSION (EVAP) SYSTEM LEAK DETECTION PUMP REMOVAL/INSTALLATION [LF] .).
- If as specified, carry out the CIRCUIT OPEN/SHORT INSPECTION .
EVAP SYSTEM LEAK DETECTION PUMP TERMINALS RESISTANCE SPECIFICATIONS
Terminals
Resistance (ohm)
A-B
20-50
A-C
26.6-32.4
A-D
MAX. 118
‹ Prev Evaporative emission (evap) system leak detection pump inspection [lf]Next › Circuit open/short inspection
Parts & tools for this job For 2006 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 2006 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.