Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Egr valve inspection [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Emission System › Egr valve inspection [lf]
Engine performanceEgr valve inspection [lf] · page 1 of 2
ENGINE PERFORMANCE – Emission System – figure
Fig. 27: Removing EGR Valve With Engine Coolant Hose (With Torque Specifications)
Courtesy of MAZDA MOTORS CORP.
  1. Disconnect the engine coolant hose from the EGR valve.
  2. Replace the EGR valve gasket.
  3. Install in the reverse order of removal.

EGR VALVE INSPECTION [LF]

NOTE: Perform the following procedure only when directed.

ON-VEHICLE INSPECTION

  1. Verify that the buzzing sound (valve operation sound) is heard from the EGR valve when engine cranking.
    • If the buzzing sound is not heard, perform the resistance inspection.

RESISTANCE INSPECTION

  1. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION [LF] .)
  2. Disconnect the battery cover.
  3. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.