Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure (page 5 of 5)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 5 of 5
Start the engine and idle it.
Access LONG FT1
PID.
Measure LONG FT1
PID at idle.
Is PID value normal? (See PCM
INSPECTION [LF] .)
Less than specification (too rich):
Greater than specification (too lean):
• Inspect EVAP control system.
• If system is normal, go to Step 14.
• Inspect for air leakage at intake-air system components.
• If system is normal, go to the next step.
15Disconnect the vacuum hose between the purge solenoid valve and the intake manifold from purge solenoid valve side.
Plug opening end of vacuum hose.
Start the engine.
Does the engine condition improve?
YesCheck if purge solenoid valve is stuck open mechanically.
Inspect EVAP control system.
NoGo to the next step.
16Remove and shake the
PCV valve.
Does the PCV valve rattle?
YesGo to the next step.
NoReplace the PCV valve.
17Visually inspect the exhaust system part.
Is there any deformed exhaust system part?
YesReplace the suspected part.
NoGo to the next step.
18Visually inspect the
CMP sensor and teeth of camshaft.
Are the CMP sensor and teeth of camshaft normal?
YesGo to the next step.
NoReplace the malfunctioning part.
19Inspect the engine condition while tapping
EGR valve housing.
Does the engine condition improve?
YesReplace the EGR valve.
NoGo to the next step.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.