Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure (page 3 of 5)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 3 of 5
Connect pressure gauge to A/C low and high pressure side lines.Start engine and idle it.Turn the A/C switch on.Measure low side and high side pressures.Are pressures within specifications? (See REFRIGERANT
PRESSURE
CHECK .)
other symptoms exist, go to the next step.RUNS CONTINUOUSLY [LF] .
For other symptoms, inspect the following:
• Refrigerant charging amount
• Condenser fan operation
7NOTE:
• The following test is for engine running rough with P/S on. If other symptoms exist, go to the next step.
Connect the M-MDS or equivalent to the DLC- 2.Start the engine and idle it.Retrieve any
DTCs for EPS.Is there any EPS DTC displayed?
YesGo to appropriate the DTC inspection. (See DTC TABLE [LF] .)
NoGo to the next step.
8Visually inspect the
CKP sensor and teeth of crankshaft pulley.
Are the CKP sensor and teeth of crankshaft pulley normal?
YesGo to the next step.
NoReplace the malfunctioning part.
9Inspect the ignition coil related wiring harness condition (intermittent open or short circuit) for all cylinders. Are wiring harness conditions normal?YesGo to the next step.
NoRepair the wiring harnesses.

10

Inspect the spark plug

Yes

Spark plug is wet or covered

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.