Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure (page 2 of 5)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 2 of 5

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

Are all items normal?intake manifold and components attached to intake manifold: EGR valve
• Ignition wiring
• Electrical connections
• Fuses
• Smooth operation of throttle valve
• PCM GND circuit (1AZ, 1BB, 1BD, 1BH)
3Connect the M-MDS or equivalent to the DLC- 2.
Turn the ignition switch to the ON position (Engine off).
Retrieve any DTCs.
Are there any DTCs displayed?
YesDTC is displayed:
Go to the appropriate DTC inspection. (See DTC TABLE [LF] .)
NoNo DTC is displayed:
Go to the next step.
4Is the engine overheating?YesGo to symptom troubleshooting
NO.17 COOLING SYSTEM
CONCERNS- OVERHEATING [LF] .
NoGo to the next step.
5Connect the M-MDS or equivalent to the DLC- 2.
Access MAF PID.
Drive vehicle with monitoring PID. Is
MAF PID within specification?
YesGo to the next step.
NoInspect for open or short circuit of MAF sensor and related wiring harness.
YesGo to the next step.
6
NOTE:
  • The following No If the A/C is always on, go to test is for symptom troubleshooting engine running NO.24 A/C IS ALWAYS ON at rough idle OR A/C COMPRESSOR with A/C on. If

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.