Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting › Diagnostic procedure
Engine performanceDiagnostic procedure · page 1 of 2
  • Cruise control system operation improperly
  • Improper load signal input
  • Improper operation of electronic throttle control system

DIAGNOSTIC PROCEDURE

FAST IDLE/RUNS ON DIAGNOSTIC PROCEDURE TABLE

STEPINSPECTIONRESULTSACTION
1Connect the M-MDS or equivalent to the DLC-2.
Access ECT PID.
Start and warm up engine to normal operating temperature.
Is ECT PID between 82- 112°C {180-234°F} ?
YesGo to the next step.
NoECT PID is higher than
112°C {234°F}:
Go to symptom troubleshooting NO.17
COOLING SYSTEM
CONCERNS- OVERHEATING [LF] .
ECT PID is less than
82°C {180°F}:
Go to symptom troubleshooting NO.18
COOLING SYSTEM
CONCERNS-RUNS
COLD [LF] .
2Connect the M-MDS or equivalent to the DLC-2.
Turn the ignition switch to the ON position (Engine off).
Retrieve any DTCs.
Are there any DTCs displayed?
YesDTC is displayed:
Go to the appropriate
DTC inspection. (See DTC TABLE [LF] .)
NoNo DTC is displayed:
Go to the next step.
YesGo to the next step.
3
Access and monitor

AC_REQ, CPP (MT),

No

If the AC_REQ PID is

CPP/PNP (MT), and TR

not normal:

(AT) PIDs. Are PIDs values normal?

  • Inspect A/C switch,

(See PCM

refrigerant pressure

INSPECTION [LF] .)

switch, and fan switch, and related wiring harness for vibration or intermittent open/short circuit.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.