Diagnostic procedure
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Symptom Troubleshooting › Diagnostic procedure
Engine performanceDiagnostic procedure
PRECAUTION [LF] .)
(See AFTER SERVICE PRECAUTION [LF] .)
CAUTION: Disconnecting/connecting quick release connector without cleaning it may cause damage to fuel pipe and quick release connector. Always clean quick release connector joint area before disconnecting/connecting, and make sure that it is free of foreign material.
DIAGNOSTIC PROCEDURE
FUEL ODOR (IN ENGINE COMPARTMENT) DIAGNOSTIC PROCEDURE TABLE
| STEP | INSPECTION | RESULTS | ACTION |
|---|---|---|---|
| 1 | Visually inspect for fuel leakage at fuel injector O-ring and fuel line. Service if necessary. Install the fuel pressure gauge between the fuel pipe and the fuel distributor. Start engine and idle it. Measure fuel line pressure during idle. Is fuel line pressure correct during idle? (See FUEL LINE PRESSURE INSPECTION [LF] .) | Yes | Go to the next step. |
| No | Replace the fuel pump unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION | ||
| [LF] .) | |||
| 2 | Inspect for blockage/restriction or open circuit in wiring harness between the engine vacuum port and the charcoal canister. Inspect for blockage in fuel tank vent system. Is malfunction indicated? | Yes | Replace vacuum hose. |
| No | Go to the next step. | ||
| Yes | Go to the next step. 3 Inspect the purge |
Parts & tools for this job For 2006 Mazda MX-5
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.