Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting › Diagnostic procedure
Engine performanceDiagnostic procedure

PRECAUTION [LF] .)

(See AFTER SERVICE PRECAUTION [LF] .)

CAUTION: Disconnecting/connecting quick release connector without cleaning it may cause damage to fuel pipe and quick release connector. Always clean quick release connector joint area before disconnecting/connecting, and make sure that it is free of foreign material.

DIAGNOSTIC PROCEDURE

KNOCKING/PINGING-ACCELERATION/CRUISE DIAGNOSTIC PROCEDURE TABLE

STEPINSPECTIONRESULTSACTION
1Connect the M-MDS or equivalent to the DLC- 2.
Access ECT PID.
Verify ECT PID is less than 116°C {241°F} during driving.
Is ECT PID less than specification?
YesGo to the next step.
NoInspect the cooling system for cause of overheating.
2Connect the M-MDS or equivalent to the DLC- 2.
Access IAT and MAF
PIDs.
Monitor each PID. (See PCM
INSPECTION [LF] .)
Are PIDs normal?
YesGo to the next step.
NoIAT PID : Inspect IAT sensor
MAF PID : Inspect MAF sensor
3Connect the M-MDS or equivalent to the DLC- 2.
Turn the ignition switch to the ON position (engine off).
Are there any DTCs displayed?
YesDTC is displayed:
Go to the appropriate DTC inspection. (See DTC TABLE [LF] .)
NoNo DTC is displayed:
Go to the next step.
YesGo to the next step.
4
Is engine compression

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.