Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Intermittent concern troubleshooting [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting › Intermittent concern troubleshooting [lf]
Engine performanceIntermittent concern troubleshooting [lf]

[LF] .)

17

  • Verify test results.
  • If normal, return to diagnostic index to service any additional symptoms.

(See ENGINE SYMPTOM TROUBLESHOOTING [LF] .)

  • If malfunction remains, inspect related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis.
  • If vehicle is repaired, troubleshooting completed.
  • If vehicle is not repaired or additional diagnostic information is not available, replace the PCM.

(See PCM REMOVAL/INSTALLATION [LF] .)

INTERMITTENT CONCERN TROUBLESHOOTING [LF]

VIBRATION METHOD

  • If malfunction occurs or becomes worse while driving on a rough road or when the engine is vibrating, perform the steps below.

NOTE: There are several reasons vehicle or engine vibration could cause an electrical malfunction. Inspect the following:

Connectors not fully seated

Wiring harnesses not having full play

Wiring harnesses laying across brackets or moving parts

Wiring harnesses routed too close to hot parts

An improperly routed, improperly clamped, or loose wiring harness can cause wiring to become pinched between parts.

The connector joints, points of vibration, and places where wiring harnesses pass such as through the firewall and body panels are the major areas to be checked.

Inspection Method for Switch Connectors or Wiring Harnesses

  1. Connect the M-MDS or equivalent to the DLC-2.
  2. Turn the ignition switch to the ON position (Engine off).

NOTE: If the engine starts and runs, perform the following steps during idle.

  1. Access PIDs for the switch you are inspecting.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.