Diagnostic procedure (page 5 of 5)
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 5 of 5
Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.
| started.) (See PURGE CONTROL SYSTEM INSPECTION .) Is the purge control correct? | No | Repair or replace the malfunctioning part. | |
| 14 | Perform compression inspection. (See COMPRESSION INSPECTION [LF] .) Is compression correct? | Yes | Visually inspect for deformed exhaust system part. |
| No | Repair or replace the malfunctioning part. | ||
| 15 | When the engine cannot be started, inspect the intake-air system for air leakage. When the engine can be started, perform intake manifold vacuum inspection. Is air sucked in from intake-air system? | Yes | Repair or replace the malfunctioning part. |
| No | Go to the next step. | ||
| Yes | Inspect the following PIDs: • ECT • O2S11 • O2S12 • MAF (See PCM INSPECTION [LF] .) Inspect PCM GND condition. 16 Install the fuel pressure gauge between the fuel filter and the fuel distributor. Short check connector terminal F/P to body GND using a jumper wiring. Turn the ignition switch to the ON position (Engine off). Is fuel line pressure | ||
| Zero or low: Inspect the fuel pump relay and fuel pump circuit. Inspect the fuel line for clogging. If there is no malfunction, replace the fuel pump unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION correct with the ignition switch at ON? (See FUEL LINE PRESSURE INSPECTION [LF] .) No | |||
| [LF] .) High: Replace the fuel pump unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION |
Parts & tools for this job For 2006 Mazda MX-5
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.