Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure (page 3 of 5)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 3 of 5

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

distributor.
Short check connector terminal F/P to body
GND using a jumper wiring.
Turn the ignition switch to the ON position (Engine off).
Is the fuel line pressure correct with the ignition switch at ON? (See FUEL LINE
No• Open or short circuit in injector
• Leakage
• Injection volume
Zero or low:
Inspect the fuel pump relay and fuel pump circuit.
Inspect the fuel line for clogging.
If there is no malfunction, replace the fuel pump unit.
PRESSURE(See FUEL PUMP UNIT
INSPECTION [LF] .)REMOVAL/INSTALLATION
[LF] .)
High:
Replace the fuel pump unit. (See FUEL PUMP UNIT
REMOVAL/INSTALLATION
[LF] .)
7Inspect the spark plug for the following.
• Heat range
• Air gap
Yes
No
Go to the next step.
Replace the spark plug. (See SPARK PLUG
REMOVAL/INSTALLATION [LF] .)
Is the spark plug normal?
8Remove the suspected fuel injector.
Inspect the following:
• Resistance (See FUEL
YesInspect for open circuit in wiring harness between fuel injector connector terminal B and PCM at the following terminals:
• For No.1 cylinder: 2BB
INJECTOR
INSPECTION [LF] .)
• Fuel injection volume (See FUEL
• For No.2 cylinder: 2BC
• For No.3 cylinder: 2BD
• For No.4 cylinder: 2AZ
INJECTOR
INSPECTION
[LF] .)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.