Diagnostic procedure (page 2 of 5)
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Symptom Troubleshooting
Engine performanceDiagnostic procedure · page 2 of 5
Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.
| Inspect spark plug condition. Is spark plug condition normal? | No | Specific plug is wet or covered with carbon: Go to the next step. Specific plug looks grayish white: Go to Step 7. All plugs are wet or covered with carbon: Go to Step 9. All plugs look grayish white: Go to Step 15. | |
| 2 | Are the spark plug wet/covered with carbon by the engine oil? | Yes | Inspect all areas related to oil, working up and down. |
| No | Go to the next step. | ||
| 3 | Inspect the spark plug for the following: • Cracked insulator • Heat range • Air gap • Worn electrode Is the spark plug normal? | Yes | Go to the next step. |
| No | Replace the spark plug. (See SPARK PLUG REMOVAL/INSTALLATION | ||
| [LF] .) | |||
| 4 | Inspect compression pressure at suspected malfunctioning cylinder. Is compression pressure correct? (See COMPRESSION INSPECTION [LF] .) | Yes | Go to the next step. |
| No | Repair or replace the malfunctioning part. | ||
| 5 | Install all spark plugs. Perform the spark test at suspected malfunctioning cylinder. Is strong blue spark visible? (Compare with normal cylinder.) | Yes | Go to the next step. |
| No | Repair or replace the malfunctioning part. |
6
Install the fuel pressure
Yes
Inspect fuel injector for the
gauge between fuel
following:
filter and fuel
Parts & tools for this job For 2006 Mazda MX-5
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.