Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Egr control system inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting › Egr control system inspection
Engine performanceEgr control system inspection

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

terminal
2AX
• Ignition coil
No.4 terminal C- PCM terminal 2AT
• Are the wiring harnesses normal?
5• Measure the voltage at terminal
A in each ignition coils.
• Is the voltage B+ ?
YesGo to the next step.
NoInspect power supply circuit of ignition coils.
6Verify continuity between each ignition coils terminal B and battery negative post.
Is there any continuity?
YesGo to the next step.
NoInspect GND circuit of ignition coils.
7• Does the PCM connector or ignition coil connectors have poor connection?YesRepair or replace the connector, then go to
Step 1.
NoGo to the next step.
8• Are the following parts normal?
• CKP sensor and crankshaft pulley
YesInspect for open or short circuit in wiring harness and connector of CKP sensor.
NoRepair or replace the malfunctioning part, then go to Step 1.

EGR CONTROL SYSTEM INSPECTION

If simulation function of M-MDS is used:

  1. Crank the engine and verify that EGR valve operation (initial operation) sound is heard.
    • If the operation sound is not heard, connect the M-MDS or equivalent to the DLC-2 and verify that the DTC P0403 is shown. Perform the DTC inspection. (See DTC TABLE [LF] .)
  2. Start the engine run it at idle.
  3. Increase the step value of EGR valve from 0 to 52 using SEGR PID of simulation function.
  4. Operate the EGR valve and inspect if the engine speed becomes unstable or the engine stalls.
    • If the engine speed will not change, proceed to following.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.