Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Dtc table

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS) › Dtc table
BrakesDtc table
  • Select "ABS".
  • Select "DataLogger".
  1. Select the active command modes from the PID table.
  2. Perform the active command modes, inspect the operations for each parts.
    • If there is no operation sound from the relay, motor, and solenoid after the active command mode inspection is performed, it is possible that there is an open or short circuit in the wiring harness, relay, motor or solenoid, or sticking and operation malfunction.
BRAKES – On-Board Diagnostic (ABS) – figure
Fig. 5: Locating DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.

DTC TABLE

DTC TABLE

DTCSystem malfunction location
M-MDS
B1317Power supply system
B1318Power supply system
B1342ABS HU/CM system
B1484Brake switch system
B2477ABS HU/CM configuration

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.