Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Dtc c1186, c1266 [ABS]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS) › Dtc c1186, c1266 [ABS]
BrakesDtc c1186, c1266 [ABS]

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the memory.
• (See Clearing DTCs
Procedures .)
• Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more.
• Are the same DTCs present?
(See DSC HU/CM
REMOVAL/INSTALLATION .)
NoGo to the next step.
5VERIFY AFTER REPAIR
PROCEDURE
• Are any other DTCs present?
YesGo to the applicable DTC inspection. (See DTC Table .)
NoDTC troubleshooting completed.

DTC C1186, C1266 [ABS]

DTC C1186, C1266 POSSIBLE CAUSE TABLE

DTC C1186, C1266Fail-safe relay system
DETECTION CONDITION• C1186
• ABS HU/CM internal valve relay remains OFF when valve relay ON is commanded.
• C1266
• ABS HU/CM internal valve relay remains ON (stuck) when valve relay
OFF is commanded.
POSSIBLE CAUSE• ABS 30 A fuse malfunction
• Open circuit or short to ground in the wiring harness between the battery and the ABS
HU/CM terminal C
• Open or short circuit in the ABS HU/CM internal valve relay, or stuck valve relay
• Poor connection at connectors (female terminal)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.