Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Diagnostic procedure (page 2 of 2)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS)
BrakesDiagnostic procedure · page 2 of 2

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

LR_WSPD
RF_WSPD
RR_WSPD
• Start the engine and drive the vehicle.
• Verify that the PIDs of the four ABS wheel- speed sensors correspond approximately.
• Do the vehicle speeds correspond?
2INSPECT IF
MALFUNCTION
OCCURRED DUE TO
IMPROPER SENSOR
CLEARANCE
• Inspect the clearance between the ABS wheel-speed sensor and the ABS sensor rotor.
Clearance
Front: 0.3-1.0 mm {0.012-0.057 in}
Rear: 0.8-1.6 mm {0.032-0.062 in}
YesGo to the next step.
NoReplace the rear ABS wheel-speed sensor, then go to Step 4. (See FRONT ABS WHEEL-SPEED
SENSOR
REMOVAL/INSTALLATION .) (See REAR ABS WHEEL-SPEED
SENSOR
REMOVAL/INSTALLATION .)
3VISUALLY INSPECT
ABS SENSOR ROTOR
FOR FOREIGN
MATERIAL ADHERING
OR IMPROPER
INSTALLATION
• Is the result normal?
YesGo to the next step.
NoReplace the front wheel hub component or rear drive shaft, then go to the next step. (See WHEEL HUB, STEERING
KNUCKLE
REMOVAL/INSTALLATION .) (See REAR DRIVE SHAFT
REMOVAL/INSTALLATION .)

4

VERIFY DTC

Yes

Repeat the inspection from Step 1.

TROUBLESHOOTING

If the malfunction recurs, replace the

COMPLETED

DSC HU/CM.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.