Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Active command modes procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS) › Active command modes procedure
BrakesActive command modes procedure
BRAKES – On-Board Diagnostic (ABS) – figure
Fig. 4: Locating DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.

NOTE: The PID data screen function is used for monitoring the calculated value. Therefore, if the monitored value of the output parts is not within specification, inspection of the monitored value of input parts corresponding to applicable output part control is necessary. In addition, because the system does not display output part malfunction as abnormality in the monitored value, it is necessary to inspect the output part individually using a active command modes function.

ACTIVE COMMAND MODES PROCEDURE

  1. Connect the M-MDS to the DLC-2.
  2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
    • Select the "Toolbox" tab.
    • Select "DataLogger".
    • Select "Modules".
    • Select "ABS".
    • When using the PDS (Pocket PC)
    • Select "Modules Tests".

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.