Diagnostic procedure
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- On-Board Diagnostic (ABS) › Diagnostic procedure
‹ Prev Dtc c1194, c1198, c1210, c1214, c1242, c1246, c1250, c1254 [ABS]Next › Dtc c1233, c1234, c1235, c1236 [ABS]
BrakesDiagnostic procedure
(female terminal)
DIAGNOSTIC PROCEDURE
DTC C1194, C1198, C1210, C1214, C1242, C1246, C1250, C1254 DIAGNOSTIC PROCEDURE TABLE
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | VERIFY SOLENOID VALVE OPERATION • Turn the ignition switch off. • Connect the M-MDS to the DLC-2. • Turn the ignition switch to the ON position (engine off). • Access the active command mode for the solenoid valve using the M-MDS. • Does the solenoid valve operate? | Yes | Go to the next step. |
| No | Replace the ABS HU/CM, then go to the next step. (See ABS HU/CM REMOVAL/INSTALLATION .) | ||
| 2 | VERIFY DTC TROUBLESHOOTING COMPLETED • Clear the DTC from the memory. • (See CLEARING DTCS PROCEDURES .) • Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more. • Gradually slow down and stop vehicle. • Are the same DTCs present? | Yes | Repeat the inspection from Step 1. If the malfunction recurs, replace the ABS HU/CM, then go to the next step. (See ABS HU/CM REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY AFTER REPAIR PROCEDURE • Are any other DTCs present? | Yes | Go to the applicable DTC inspection. (See DTC Table .) |
| No | DTC troubleshooting completed. | ||
‹ Prev Dtc c1194, c1198, c1210, c1214, c1242, c1246, c1250, c1254 [ABS]Next › Dtc c1233, c1234, c1235, c1236 [ABS]
Parts & tools for this job For 2006 Mazda MX-5
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.