Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Dtc b2477 [ABS]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS) › Dtc b2477 [ABS]
BrakesDtc b2477 [ABS]
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the memory.
• (See CLEARING
DTCS
PROCEDURES .)
• Are the same DTCs present?
NoGo to the next step.
4VERIFY AFTER REPAIR
PROCEDURE
• Are any other DTC present?
YesGo to the applicable DTC inspection. (See DTC Table .)
NoDTC troubleshooting completed.

DTC B2477 [ABS]

DTC B2477 POSSIBLE CAUSE TABLE

DTC B2477ABS HU/CM configuration
DETECTION CONDITION• Configuration setting failure is detected.
POSSIBLE CAUSE• Module configuration procedure was not completed properly.

DIAGNOSTIC PROCEDURE

DTC B2477 DIAGNOSTIC PROCEDURE TABLE

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

STEP
1
INSPECTION
VERIFY
Yes
CONFIGURATION
No
• Has the ABS HU/CM configuration been performed?
ACTION
Go to the next step.
Perform configuration using the M- MDS. (See ABS CONFIGURATION .)
2VERIFY DTC
TROUBLESHOOTING
COMPLETED
YesRepeat the inspection from Step 1.
If the malfunction recurs, replace the
ABS HU/CM. (See ABS HU/CM
• Clear the DTC fromREMOVAL/INSTALLATION .)
the memory.
• (See CLEARING
DTCS

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.