Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Diagnostic procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS) › Diagnostic procedure
BrakesDiagnostic procedure
BRAKES – On-Board Diagnostic (ABS) – figure

DIAGNOSTIC PROCEDURE

DTC B1484 DIAGNOSTIC PROCEDURE TABLE

STEPINSPECTIONACTION
1INSPECT ABS HU/CM
TO BRAKE SWITCH
FOR OPEN CIRCUIT
• Turn the ignition switch off.
• Disconnect the ABS
HU/CM and brake switch connector.
• Inspect for continuity
ABS HU/CM terminal
N and brake switch terminal D.
• Is there continuity?
YesGo to the next step.
NoRepair or replace the wiring harness for open circuit between ABS HU/CM and brake switch, then go to the next step.
2INSPECT BRAKE
SWITCH
• Inspect the brake switch.
• (See BRAKE
SWITCH
INSPECTION .)
• Is the brake switch normal?
YesGo to the next step.
NoReplace the brake switch, then go to the next step. (See BRAKE PEDAL
REMOVAL/INSTALLATION .)

3

VERIFY

Yes

Replace the ABS HU/CM, then go to

TROUBLESHOOTING

the next step.

COMPLETED

(See ABS HU/CM REMOVAL/INSTALLATION .)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.