Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Diagnostic procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS) › Diagnostic procedure
BrakesDiagnostic procedure · page 1 of 2
BRAKES – On-Board Diagnostic (ABS) – figure

DIAGNOSTIC PROCEDURE

DTC C1095, C1096 DIAGNOSTIC PROCEDURE TABLE

STEPINSPECTIONACTION
1INSPECT ABS FUSE
CONDITION
• Is the ABS 40A fuse normal?
YesGo to the next step.
NoReplace the fuse, then go to Step 5.
2INSPECT MOTOR
RELAY POWER SUPPLY
FOR OPEN CIRCUIT
• Turn the ignition switch off.
• Disconnect ABS
HU/CM connector.
• Turn the ignition switch to the ON position (engine off).
• Measure voltage between ABS HU/CM terminal B (harness- side) and ground.
• Is the voltage B+ ?
YesGo to the next step.
NoRepair or replace the wiring harness for open circuit between battery positive terminal and ABS HU/CM terminal B, then go to Step 5.

3

INSPECT PUMP MOTOR Yes

Go to the next step.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.