Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Diagnostic procedure (page 2 of 2)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS)
BrakesDiagnostic procedure · page 2 of 2
GROUND FOR OPEN
CIRCUIT
• Turn the ignition switch off.
• Inspect for continuity between ABS HU/CM terminal A (harness- side) and ground.
• Is there continuity?
NoRepair or replace the wiring harness for open circuit between ABS HU/CM terminal A and ground, then go to Step
5.
4VERIFY PUMP MOTOR
OPERATION
• Turn the ignition switch off.
• Connect the M-MDS to the DLC-2.
• Turn the ignition switch to the ON position (engine off).
• Access PMP_MOTOR active command modes using M-MDS.
• Does the pump motor operate?
YesGo to the next step.
NoReplace the ABS HU/CM, then go to the next step. (See ABS HU/CM
REMOVAL/INSTALLATION .)
YesReplace the ABS HU/CM, then go to the next step. (See ABS HU/CM
REMOVAL/INSTALLATION .)
5
VERIFY
TROUBLESHOOTING
COMPLETED
Make sure to
reconnect all
disconnected
connectors.
Clear the DTC from
the memory.
(See CLEARING
DTCS
PROCEDURES .)
Start the engine and
drive the vehicle at 10
km/h {6.2 mph} or
more.

No

Go to the next step.

  • Gradually slow down and stop the vehicle.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.