Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Diagnostic procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS) › Diagnostic procedure
BrakesDiagnostic procedure · page 1 of 2
wheels indicate abnormal acceleration that exceeds specification.
• Vehicle wheel speed signals of any of the four vehicle wheels indicate speed that exceeds specification.
POSSIBLE CAUSE• ABS wheel-speed sensor malfunction (low output, metal shavings on sensor)
• ABS sensor rotor malfunction (chipping of sensor rotor teeth)
• Poor installation of ABS wheel-speed sensor and/or sensor rotor (If the sensor rotor is installed at an angle, it may cause output of abnormal wave pattern at high speeds.)
• Excessive clearance between the ABS wheel- speed sensor and sensor rotor

DIAGNOSTIC PROCEDURE

DTC C1148, C1158, C1168, C1178 DIAGNOSTIC PROCEDURE TABLE

STEPINSPECTIONACTION
YesGo to Step 4.
1
INSPECT PID FOR
ABNORMAL OUTPUT
FROM ABS WHEEL-
SPEED SENSOR USING
M-MDS
Turn the ignition
switch off.
Connect the M-MDS
to the DLC-2.
Select the following

No

If there is a difference in speeds of the

PIDs using the M-

four wheels, go to the next step.

MDS:

LF_WSPD

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.