Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Dtc c1805 [ABS]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS) › Dtc c1805 [ABS]
BrakesDtc c1805 [ABS] · page 1 of 2

output?

DTC C1805 [ABS]

DTC C1805 POSSIBLE CAUSE TABLE

DTC C1805Incorrect ABS HU/CM installed
DETECTION CONDITION• The programmed vehicle information and the data received from the CAN do not correspond.
POSSIBLE CAUSE• The correct ABS HU/CM is not installed.

DIAGNOSTIC PROCEDURE

DTC C1805 DIAGNOSTIC PROCEDURE TABLE

STEPINSPECTIONACTION
1VERIFY THAT THE
CORRECT ABS HU/CM
IS INSTALLED
• Verify the part number of the ABS HU/CM.
• Is the part number correct?
YesGo to the next step.
NoAfter replacing the ABS, go to Step 3. (See ABS HU/CM
REMOVAL/INSTALLATION .)
2PERFORM
CONFIGURATION
• Was configuration performed normally?
YesGo to the next step.
NoReplace the ABS HU/CM, then go to the next step. (See ABS HU/CM
REMOVAL/INSTALLATION .)
3VERIFY DTC
TROUBLESHOOTING
COMPLETED
• Make sure to reconnect all disconnected connectors.
• Clear the DTC from the memory.
• (See CLEARING
DTCS
PROCEDURES .)
• Is the same DTC present?
YesRepeat the inspection from Step 1.
If the malfunction recurs, replace the
ABS HU/CM, then go to the next step. (See ABS HU/CM
REMOVAL/INSTALLATION .)
NoGo to the next step.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.