Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Diagnostic procedure (page 3 of 3)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS)
BrakesDiagnostic procedure · page 3 of 3
speed sensor (+): M-A
• RF ABS wheel- speed sensor (-):
O-B
• LF ABS wheel- speed sensor (+): F-A
• LF ABS wheel- speed sensor (-):
E-B
• RR ABS wheel- speed sensor (+): I-A
• RR ABS wheel- speed sensor (-):
L-B
• LR ABS wheel- speed sensor (+): G-A
• LR ABS wheel- speed sensor (-):
H-B
• Is there continuity?
NoRepair or replace the wiring harness, then go to the next step.
3VERIFY THAT THE
SAME DTC IS NOT
PRESENT
• Clear the DTCs from the memory.
• (See CLEARING
DTCS
PROCEDURES .)
• Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more.
• Are the same DTCs present?
YesRepeat the inspection from Step 1.
If the malfunction recurs, replace the
ABS HU/CM, then go to the next step. (See ABS HU/CM
REMOVAL/INSTALLATION .)
NoGo to the next step.

4

VERIFY THAT NO

Yes

Go to the applicable DTC inspection.

OTHER DTCS ARE

(See DTC Table .)

PRESENT

  • Are any other DTCs

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.