Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Dtc c1095, c1096 [ABS]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS) › Dtc c1095, c1096 [ABS]
BrakesDtc c1095, c1096 [ABS]
PROCEDURES .)
• Is the same DTC present?
NoGo to the next step.
3VERIFY AFTER REPAIR
PROCEDURE
• Are any other DTCs present?
YesGo to the applicable DTC inspection. (See DTC Table .)
NoDTC troubleshooting completed.

DTC C1095, C1096 [ABS]

DTC C1095, C1096 POSSIBLE CAUSE TABLE

DTC C1095, C1096

Pump motor, motor relay system

  • C1095
  • When the pump motor monitor voltage remains at 2.0 V or more for 1 s
  • ABS motor monitor OFF signal is input within specified time limit when the motor signal is switched from ON to

DETECTION CONDITION

OFF by ABS HU/CM.

  • C1096
  • When the difference between the battery power supply voltage and pump motor power supply voltage remains at 4.0 V or more for 0.1 s or more while the pump motor is operating
  • ABS 40 A fuse malfunction
  • Open or short to ground circuit in the wiring harness between the battery and the ABS HU/CM terminal B
  • Open circuit in the wiring harness between the ABS HU/CM terminal A and the body ground

POSSIBLE CAUSE

  • Open or short circuit in the ABS HU/CM internal motor relay, or stuck motor relay
  • Open or short circuit in the ABS HU/CM internal motor, or frozen motor
  • Fail-safe relay malfunction
  • Poor connection at connectors (female terminal)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.