Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)07 · Brakes
07 · Brakes

Diagnostic procedure (page 2 of 3)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
On-Board Diagnostic (ABS)
BrakesDiagnostic procedure · page 2 of 3

No

Go to the next step.

  • Connect the M-MDS to the DLC-2.
  • Select the following PIDs using the M- MDS:

LF_WSPD

LR_WSPD

RF_WSPD

RR_WSPD

  • Drive the vehicle.
  • Verify that the wheel speed-signals are transmitted from each ABS wheel-speed sensor.
  • Are the wheel-speed signals transmitted?

2

INSPECT A SHORT TO

Yes

Replace the ABS wheel-speed sensor,

GROUND IN THE

then go to the next step. (See FRONT ABS WHEEL-SPEED

WIRING HARNESS

SENSOR

BETWEEN THE ABS

REMOVAL/INSTALLATION .)

HU/CM AND THE ABS

(See REAR ABS WHEEL-SPEED

WHEEL-SPEED SENSOR

SENSOR REMOVAL/INSTALLATION .)

  • Turn the ignition switch off.
  • Disconnect the ABS HU/CM connector and the ABS wheel-speed sensor connector.
  • Inspect for a short to ground in the wiring harness between the following ABS wheel-speed sensor connectors on the vehicle wiring harness-side and ABS HU/CM connectors.
  • RF ABS wheel-

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.