Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)03 · Engine performance
03 · Engine

Diagnostic procedure

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Symptom Troubleshooting › Diagnostic procedure
Engine performanceDiagnostic procedure

CAUTION: Disconnecting/connecting quick release connector without cleaning it may cause damage to fuel pipe and quick release connector. Always clean quick release connector joint area before disconnecting/connecting, and make sure that it is free of foreign material.

DIAGNOSTIC PROCEDURE

FUEL REFILL CONCERNS DIAGNOSTIC PROCEDURE TABLE

STEPINSPECTIONACTION
1Connect the M-MDS or equivalent to the DLC-2.
Turn the ignition switch to the ON position (Engine off).
Retrieve any DTCs.
Are there any DTCs displayed?
YesDTC is displayed:
Go to the appropriate
DTC inspection. (See DTC TABLE [LF] .)
NoNo DTC is displayed:
Go to the next step.
2Remove the fuel-filler pipe.
Make sure the non-return valve is installed properly.
Inspect non-return valve operation.
Is the non-return valve normal?
YesInspect for the following:
• Improper use of fuel nozzle
• Inadequate fuel filling speed
NoNon-return valve is installed improperly:
• Reinstall non- return valve to proper position.
Non-return valve does not operate properly:
• Replace non-return valve.

3

  • Verify test results.
  • If normal, return to diagnostic index to service any additional symptoms.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.