Diagnostic procedure
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Symptom Troubleshooting › Diagnostic procedure
Engine performanceDiagnostic procedure · page 1 of 2
CAUTION: Disconnecting/connecting quick release connector without cleaning it may cause damage to fuel pipe and quick release connector. Always clean quick release connector joint area before disconnecting/connecting, and make sure that it is free of foreign material.
DIAGNOSTIC PROCEDURE
EMISSION COMPLIANCE DIAGNOSTIC PROCEDURE TABLE
| STEP | INSPECTION | RESULTS | ACTION |
|---|---|---|---|
| 1 | Inspect for the following: • Vacuum lines for leakage or blockage • Electrical connections • Proper maintenance schedule followed • Intake-air system and air cleaner element concerns: obstructions, leakage or dirtiness Are all items normal? | Yes | Go to the next step. |
| No | Service if necessary. Repeat Step 1. | ||
| 2 | Connect the M-MDS or equivalent to the DLC- 2. Turn the ignition switch to the ON position (Engine off). Retrieve any DTCs. Are there any DTCs displayed? | Yes | DTC is displayed: Go to appropriate DTC inspection. (See DTC TABLE [LF] .) |
| No | No DTC is displayed: Go to the next step. |
3
Is any other driveability
Yes
Go to appropriate symptom
Parts & tools for this job For 2006 Mazda MX-5
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.